Tube Booster

Full tube booster in 9 or 12v!

This Tube Booster  is a two-function boost pedal : 

- Plugged into the front of the amp, it allows you to obtain more gain,

- Plugged into the FX loop, it increase the volume. Which is a very good way to be hear when you play a solo for example.

It's very compact, light-weight and works with only one preamp tube in 9 or 12v. It's hand made in the north of France and powered by Ecc82 (12AU7 JJ Tesla).

No PCB, only point to point wiring, like it was used to on vintage hardware. This type of wiring has proved its reliability and accessibility.

One knob, two possibilities

You have only 1 knob as settings : a gain knob which permit you to adjust the signal power. It's a "clean boost" : placed into the FX Loop, his action is transparent : of course you benefit of tube sound and dynamic (as you can hear by watching the video below), but your orginal sound is preserved.

Placed into the front of the amp, it will transform your crunch into a big overdrive,  your overdrive into a distorsion. It's a good way to ad a new channel on your amp.

But I invite you to make up your own mind by listening samples below.

Tube Booster works in 9 or 12v. Power Supply is optional. You can use your own if you have a 9 or 12v output on your pedal board (170mA in 9v minimum).

As every P&P products , it comes with a 2-year warranty, parts and service (only 3 months for tubes & power supply).

Dimensions : 112 x 68 x 48mm

Vidéo :

Samples audio

Recording method:  Marshall JVM (EL34) amp, Gibson les Paul Standard 2013,  Marshall 1960 cab.  Shure SM57 into an EDIROL interface. Logic Audio software.

• Tube Booster plugged in front of the amp (cliquez ici pour écouter)
• Tube Booster plugged into the FX loop of the amp (cliquez ici pour écouter)

More pictures